![]() This is subject to change further on as the software is finalized. Remember that the current cuttable area is only 10.97" by 19.47" though, and the engravable area is somewhat smaller depending on the speed used. There is also a workaround that corrects for resizing issues that works for that artboard size. If you see this happen a lot, lower the LPI you are using.Ĭreating an artboard or canvas size for your design of 20" x 12" will give you a good idea of how much you can fit into your layout, and it’s a good idea to just use a standard size. Large surface area images with high pixel resolution can result in an indeterminate error message when they get hung up in the buffer in the Glowforge User Interface (GFUI). I like to use **300 ppi or less for large engraves, the GFUI can handle up to 600 ppi. ![]() If you are going for an engrave of a bitmap larger than half the bed height, try to keep your raster (bitmap) images at a reasonable size. There are instructions for how to Embed raster images for some of the main 2D vector programs in the Matrix. (That’s fine, but you will completely lose the benefit of more accurate alignment that you get from the design software.) Otherwise you will need to re-load the raster file and use the camera to align it visually. If you want to engrave a bitmap (raster) style image and include it inside a vector SVG file, you need to Embed the image in the file if you want it to stay aligned inside the SVG file.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |